Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.
100 BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Duplex (10B-FD) or Half Duplex (10B-HD) will fix the print server link mode. This change is valid after the print server has been reset. The default setting is Auto.
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
| 1 | Press any of the Menu buttons (+, -, OK or Back) of the control panel on your machine. |
| 2 | Press + or - to choose Network. Press OK. |
| 3 | Press + or - to choose Wired LAN. Press OK. |
| 4 | Press + or - to choose Ethernet. Press OK. |
| 5 | Press + or - to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD. Press OK. |
