Function table and factory default settings

The factory default settings are shown in Bold with asterisks.

(HL-3040CN)

(HL-3070CW)

Level one	Level two	Level three	Level four	Options
Network	Wired LAN	TCP/IP	Boot Method	Auto* , Static , RARP , BOOTP , DHCP
			IP Address	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			Subnet Mask	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			Gateway	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			IP Boot Tries	0 to 32767 3*
			APIPA	On* , Off
			IPv6	On , Off*
		Ethernet	-	Auto* , 100B-FD , 100B-HD , 10B-FD , 10B-HD
		Set to Default	-	OK?
		Wired Enable	-	On*, Off
	WLAN	TCP/IP	Boot Method	Auto* , Static , RARP , BOOTP , DHCP
			IP Address	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			Subnet Mask	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			Gateway	[000-255] . [000-255] . [000-255] . [000-255] [000-000] . [000-000] . [000-000] . [000-000]*
			IP Boot Tries	0 to 32767 3*
			APIPA	On* , Off
			IPv6	On , Off*
		SES/WPS/AOSS	-	See Wireless configuration using SES/WPS or AOSS from the control panel (For HL-3070CW).
		WPS w/PIN Code	-	See Wireless configuration using the PIN Method of Wi-Fi Protected Setup (For HL-3070CW).
		WLAN Status	Status	See Status.
			Signal	See Signal.
			Channel	See Channel.
			Speed	See Speed.
			SSID	See SSID.
			Comm. Mode	See Comm. Mode.
		Set to Default	-	OK?
		WLAN Enable	-	On , Off*
	Factory Reset	-	-	Restart Printer?