Search

Home > Paper Handling > Load Paper > Load and Print Using the Paper Tray > Load and Print Thick Paper Using the Paper Tray

Load and Print Thick Paper Using the Paper Tray

  • If, when the Check Paper setting is set to On and you pull the paper tray out of the machine, a message appears on the LCD asking if you want to change the paper size and paper type, change these settings, if needed, following the LCD instructions.

  • When you load a different size and type of paper in the tray, you must also change the Paper Size and Paper Type settings on the machine, or on your computer.
  1. Pull the paper tray completely out of the machine.
    image
  2. Press the green levers to slide the paper guides to fit the paper.
    image
    image

    For Legal or Folio size paper, press the release button (1) in the bottom of the paper tray or the release lever (2) in the back of the tray, and then pull out the back of the paper tray. (Legal and Folio size paper are not available in some regions.)

    For trays with a release button:

    image

    For trays with a release lever:

    image
  3. Fan the stack of paper well.
  4. Load paper in the paper tray with the printing surface face down.
    image

    DO NOT load different sizes and types of paper in the paper tray at the same time. Doing this may cause the paper to jam or misfeed.

  5. Make sure the paper is below the maximum paper mark (image image image).
    Overfilling the paper tray will cause paper jams.
    image
  6. Slowly push the paper tray completely into the machine.
  7. Open the machine's back cover (the face up output tray).
    image
  8. Open the paper stopper.
    image
  9. Send your print job to the machine.
    image
    Change your print preferences in the Print dialog box.
  10. When finished, close the back cover (the face up output tray) until it locks in the closed position.
    image

    Close the paper stopper, and then close the back cover.

Did you find the information you needed?