Using your remote access code

Dial your fax number from a telephone or another fax machine using touch tone.

When your machine answers, immediately enter your Remote Access Code (3 digits followed by

The machine signals if it has received messages:

•	No beeps No messages received.
•	1 long beep Fax message received.

The machine gives two short beeps to tell you to enter a command. (See Remote fax commands.) The machine will hang up if you wait longer than 30 seconds before entering a command. If you enter an invalid command the machine will beep three times.

Press 9 0 to reset the machine when you have finished.

Hang up.

Note

If your machine is set to Manual mode, you can still access the remote retrieval features. Dial the fax number as normal and let the machine ring. After 2 minutes you will hear a long beep to tell you to enter the remote access code. You will then have 30 seconds to enter the code.

Page Top