Home PrintPrevious Next

Using your remote access code

1
Dial your fax number from a telephone or another fax machine using touch tone.
2
When your machine answers, immediately enter your Remote Access Code (3 digits followed by Bsymbol.tone).
3
The machine signals if it has received messages:
• 
No beeps
No messages received.
• 
1 long beep
Fax message received.
4
The machine gives two short beeps to tell you to enter a command. (See Remote fax commands.) The machine will hang up if you wait longer than 30 seconds before entering a command. If you enter an invalid command the machine will beep three times.
5
Press 9 0 to reset the machine when you have finished.
6
Hang up.
Note Note
 
If your machine is set to Manual mode, you can still access the remote retrieval features. Dial the fax number as normal and let the machine ring. After 2 minutes you will hear a long beep to tell you to enter the remote access code. You then have 30 seconds.
Page Top
Home PrintPrevious Next