Home PrintPrevious Next

5 Wireless configuration for Macintosh® using the Brother installer application

 IMPORTANT
• 
The following instructions will install your Brother machine in a network environment using the Brother installer application for Macintosh® on the CD-ROM we have provided with the machine.
• 
You can also setup your Brother machine using the machine’s control panel (recommended). You can find instructions in the supplied Quick Setup Guide or see Configuring your machine for a wireless network.
• 
If you are going to connect your Brother machine to your network, we recommend that you contact your system administrator prior to installation. You must know your wireless network settings before you proceed with this installation.

Configuration in Infrastructure mode

Before configuring the wireless settings

 IMPORTANT
• 
If you have previously configured the wireless settings of the machine, you must reset the network LAN settings before you can configure the wireless settings again. Press Menu, 5, 0 for Factory Reset, Reset and choose Yes to accept the change. The machine will restart automatically.
• 
If you are using personal Firewall software, disable it. Once you are sure that you can print, restart your personal Firewall software.
• 
You need to temporarily use an Ethernet cable during configuration.
Page Top
Home PrintPrevious Next