When you transport the machine, use the packing materials that came with your machine. If you do not pack the machine properly, you could void your warranty.
CAUTION
| | It is important to allow the machine to ‘park’ the print head after a print job. Listen carefully to the machine before unplugging it to make sure that all mechanical noise has stopped. Not allowing the machine to finish this parking process may lead to print problems and possible damage to the print head. |
| 1 | Open the ink cartridge cover. |
| 2 | Pull the lock release levers down and take out all the ink cartridges. |
| 3 | Install the yellow protective part, lift each lock release lever and push it until it clicks, and then close the ink cartridge cover. CAUTION | | If you are not able to find the yellow protective part, DO not remove the ink cartridges before shipping. It is essential that the machine be shipped with either the yellow protective part or the ink cartridges in position. Shipping without them will cause damage to your machine and may void your warranty. |
|
| 4 | Unplug the machine from the telephone wall socket and take the telephone line cord out of the machine. |
| 5 | Unplug the machine from the electrical socket. |
| 6 | Unplug the interface cable from the machine, if it is connected. |
| 7 | If your machine has a handset, remove it and the handset curled cord. |
| 8 | Wrap the machine in the bag and put it in the original carton with the original packing material. |
| 9 | Pack the printed materials and additional parts in the original carton as shown below. Do NOT pack the used ink cartridges in the carton. |
| 10 | Close the carton and tape it shut. |
