Before loading, press the corners and sides of the envelopes to make them as flat as possible.
When the back output tray is pulled down, the machine has a straight paper path from the MP tray through to the back of the machine. Use this paper feed and output method when you want to print on thick paper, bond paper, envelopes, labels or transparencies.
IMPORTANT
| | Remove each printed sheet or envelope immediately to prevent a paper jam. |
| 1 | Open the back cover (back output tray). |
| 2 | <For printing envelopes only> Pull down the two blue levers, one on the left-hand side and one on the right-hand side, toward you as shown in the illustration below. |
| 3 | Open the MP tray and lower it gently. |
| 4 | Pull out the MP tray support (1) and unfold the flap (2). |
| 5 | While pressing the paper side guide release lever, slide the paper guides to fit the width of the paper that you are going to use. IMPORTANT | | Make sure the paper guides touch the sides of the paper so it will feed properly. |
|
| 6 | Put the envelopes (up to 3), thick paper, labels or transparencies in the MP tray with the top edge first and the print side face up. Make sure that the paper stays under the maximum paper mark (  ). |
