Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT full or half duplex mode by auto negotiation.
100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD) fix the print server link mode. This change is valid after the print server has been reset (default is Auto).
Note
| |
If you incorrectly set this value, you may not be able to communicate with your print server.
|
| 1 |
Press Menu.
|
| 2 |
Press  or  to select LAN. Press OK.
|
| 3 |
Press or to select Setup Misc.. Press OK.
|
| 4 |
Press or to select Wired LAN. Press OK.
|
| 5 |
Press or to select Auto/ 100B-FD/ 100B-HD/ 10B-FD/ 10B-HD. |
| 6 |
Press Stop/Exit.
|
