2 Loading paper and documents

Loading paper and other print media

Note

To print on Photo (10 × 15 cm) or Photo L (89 × 127 mm) paper, you must use the photo paper tray. (See Loading photo paper.)

If the paper support flap is open, close it, and then close the paper support. Pull the paper tray completely out of the machine.

Lift the output paper tray cover (1).

With both hands, gently press and slide the paper side guides (1) and the paper length guide (2) to fit the paper size. Make sure that the triangular marks (3) on the paper side guides (1) and paper length guide (2) line up with the marks for the paper size you are using.

Note

When you use Legal size paper, press and hold the universal guide release button (1) as you slide out the front of the paper tray.

Fan the stack of paper well to avoid paper jams and misfeeds.

IMPORTANT

Always make sure that the paper is not curled.

Gently put the paper into the paper tray print side down and top edge in first.

Check that the paper is flat in the tray.

IMPORTANT

Be careful that you do not push the paper in too far; it may lift at the back of the tray and cause feed problems.

Gently adjust the paper side guides (1) to fit the paper with both hands.

Make sure the paper side guides touch the sides of the paper.

Close the output paper tray cover.

Slowly push the paper tray completely into the machine.

While holding the paper tray in place, pull out the paper support (

) until it clicks, and then unfold the paper support flap (

IMPORTANT

DO NOT use the paper support flap for Legal size paper.

Loading envelopes and postcards

About envelopes

•	Use envelopes that weigh between 80 to 95 g/m².
•	Some envelopes need margin settings to be set in the application. Make sure you do a test print first before printing many envelopes.

IMPORTANT

DO NOT use any of the following types of envelopes, as they will cause paper feed problems:

•	That are of a baggy construction.
•	That are embossed (have raised writing on them).
•	That have clasps or staples.
•	That are pre-printed on the inside.

Glue	Double flap

Occasionally you may experience paper feed problems caused by the thickness, size and flap shape of the envelopes you are using.

Page Top

How to load envelopes and postcards

Before loading, press the corners and sides of envelopes or postcards to make them as flat as possible.

IMPORTANT

If envelopes or postcards are ‘double-feeding,’ put one envelope or postcard in the paper tray at a time.

Put envelopes or postcards in the paper tray with the address side down and the leading edge (top of the envelopes) in first. With both hands, gently press and slide the paper side guides (1) and paper length guide (2) to fit the size of the envelopes or postcards.

Page Top

If you have problems printing on envelopes with the flap on the short edge, try the following suggestions:

1	Open the envelope flap.
2	Put the envelope into the paper tray with the address side down and the flap positioned as shown in the illustration.
3	Adjust the size and margin in your application.

Page Top