| | |
Error Message | Cause | Action |
The machine has a mechanical problem. —OR— A foreign objects such as a clip or ripped paper is in the machine. | Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power source for several minutes then reconnect it. | |
The machine has a mechanical problem. —OR— A foreign objects such as a clip or ripped paper is in the machine. | Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power source for several minutes then reconnect it. | |
Cover is Open | The scanner cover is not closed completely. | Lift the scanner cover and then close it again. |
Data Remaining | Print data is left in the machine's memory. | Re-start printing from your computer. |
Print data is left in the machine's memory. The USB cable was unplugged while the computer was sending the data to the machine. | Press Stop/Exit. The machine will cancel the job and clear it from the memory. Try to print again. | |
High Temperature | The print head is too warm. | Allow the machine to cool down. |
The machine has a mechanical problem. —OR— A foreign objects such as a clip or ripped paper is in the machine. | Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power source for several minutes then reconnect it. | |
One or more of the ink cartridges is empty. The machine will stop all print operations. | Replace the ink cartridges. (See Replacing the ink cartridges.) | |
Low Temperature | The print head is too cold. | Allow the machine to warm up. |
Media Error | The media card is either corrupted, improperly formatted, or there is a problem with the media card. | Put the card firmly into the slot again to make sure it is in the correct position. If the error remains, check the media drive by putting in another media card that you know is working. |
One or more of the ink cartridges are running out of ink. | Order a new ink cartridge. | |
No Cartridge | An ink cartridge is not installed properly. | Take out the ink cartridge and put it in again seating it properly. (See Replacing the ink cartridges.) |
No File | The media card in the media drive does not contain a .JPG file. | Put the correct media card into the slot again. |
The machine is out of paper or paper is not properly loaded in the paper tray. | Do one of the following: | |
The paper is jammed in the machine. | ||
The machine's memory is full. | Copy operation in progress Press Stop/Exit and wait until the other operations in progress finish and then try again. Printing operation in progress Reduce print resolution. (For details, see Printing for Windows® in the Software User's Guide on the CD-ROM.) | |
Paper Jam | Paper is jammed in the machine. | |
The machine has a mechanical problem. —OR— A foreign objects such as a clip or ripped paper is in the machine. | Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power source for several minutes then reconnect it. | |
The machine has a mechanical problem. —OR— A foreign objects such as a clip or ripped paper is in the machine. | Open the scanner cover and remove any foreign objects inside the machine. If the error message continues, disconnect the machine from the power source for several minutes then reconnect it. | |
Wrong USB device | A non-PictBridge compatible or broken device has been connected to the PictBridge port. | Unplug the device from the PictBridge port, then press On/Off to turn the machine off and then on again. |
| | |
or 
to choose