Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been reset (default is Auto).
Note
| | If you incorrectly set this value, you may not be able to communicate with your print server. |
| 1 | Press Menu. |
| 2 | Press  or  to choose Network. Press OK. |
| 3 | Press or to choose Wired LAN. Press OK. |
| 4 | Press or to choose Ethernet. Press OK. |
| 5 | Press  or  to choose Auto/ 100B-FD/ 100B-HD/ 10B-FD/ 10B-HD. Press OK. |
| 6 | Press Stop/Exit. |
