Search

Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network When the SSID is Not Broadcast

Configure Your Machine for a Wireless Network When the SSID is Not Broadcast

Before configuring your machine, we recommend writing down your wireless network settings. You will need this information before you continue with the configuration.

  1. Check and write down the current wireless network settings.
    Network Name (SSID)
      
    Authentication Method Encryption Mode Network Key (Password)
    Open System NONE -
    WEP
    Shared Key WEP
    WPA/WPA2-PSK/WPA3-SAE TKIP (for WPA/WPA2-PSK)
    AES
    WPA3-SAE AES

    For example:

    Network Name (SSID)
    HELLO
    Authentication Method Encryption Mode Network Key (Password)
    WPA2-PSK AES 12345678
    image
    If your router uses WEP encryption, enter the key used as the first WEP key. Your Brother machine supports the use of the first WEP key only.
  2. Press image [Settings]>[Network]>[WLAN(Wi-Fi)]>[Find Wi-Fi Network].
  3. When [Enable WLAN?] appears, press [Yes].
    The wireless setup wizard starts. To cancel, press [No].
  4. The machine searches for your network and displays a list of available SSIDs. Press image or image to display the [<New SSID>] option, and then press it.
  5. Press [OK].
  6. Enter the SSID name, and then press [OK].
    image
    For more information about how to enter text, see Related Information.
  7. Press image or image to select the Authentication Method, and then press it.
  8. Do one of the following:
    • If you selected the [Open System] option, press either [None] or [WEP].

      If you selected the [WEP] option for Encryption type, enter the WEP key, and then press [OK].

    • If you selected the [Shared Key] option, enter the WEP key, and then press [OK].
    • If you selected the [WPA/WPA2-PSK/WPA3-SAE] option, press either [TKIP+AES] or [AES].

      Enter the WPA key, and then press [OK].

    • If you selected the [WPA3-SAE] option, press [AES].

      Enter the WPA key, and then press [OK].

    image
    • For more information about how to enter text, see Related Information.
    • Your Brother machine supports the use of the first WEP key only.
  9. The machine attempts to connect to the wireless device you have selected.
If your wireless device is connected successfully, the LCD displays [Connected].

You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com.

Did you find the information you needed?