Using remote codes

Remote Activation Code

If you answer a fax call on an extension telephone, you can tell your machine to receive it by dialling the Remote Activation Code

5 1. Wait for the chirping sounds then replace the handset. (See Fax Detect.)

If you answer a fax call at the external telephone, you can make the machine receive the fax by pressing Mono Start.

Page Top

Remote Deactivation Code

If you receive a voice call and the machine is in F/T mode, it will start to sound the F/T (double) ring after the initial ring delay. If you pick up the call on an extension telephone you can turn the F/T ring off by pressing # 5 1 (make sure you press this between the rings).

If the machine answers a voice call and pseudo/double rings for you to take over, you can take the call at the external telephone by pressing Tel/R.

Page Top

Changing the remote codes

If you want to use Remote Activation, you have to turn on the remote codes. The preset Remote Activation Code is

5 1. The preset Remote Deactivation Code is # 5 1. If you want to, you can replace them with your own codes.

Press Menu, 2, 1, 4.

1.Setup Receive

4.Remote Codes

Press

to choose On (or Off).

Press OK.

Enter the new Remote Activation Code.

Press OK.

Enter the new Remote Deactivation Code.

Press OK.

Press Stop/Exit.

Note

•	If you are always disconnected when accessing your external TAD remotely, try changing the Remote Activation Code and Remote Deactivation Code to another three-digit code using the numbers 0-9, , #.
•	Remote Codes might not work with some telephone systems.

Page Top