Home PrintPrevious Next

For network users
(For models with built-in network support)

1
Put a USB Flash memory drive, CompactFlash®1, Memory Stick®, Memory Stick Pro™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™2 into your machine.
1
This product also supports CompactFlash® type1.
2
This product supports xD-Picture Card™ Type M/Type H.
2
Launch any FTP software or any web browser in which FTP is supported. (e.g. Safari, Internet Explorer)
Your browser software accesses the memory card using the FTP protocol and the network Host Name of the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP address of your Brother machine).
Your browser software appears and a list of file names on your memory card is shown.
3
Click the name of the file you want to see.
When you take out a USB Flash memory drive or memory card, do the following to prevent damage to the memory card:
1
Close the browser.
2
Wait until the Graphic (PhotoCapture) key stops blinking before taking out the memory card.
CAUTION CAUTION
 
DO NOT unplug the power cord, USB cable or remove a USB Flash memory drive, CompactFlash®, Memory Stick®, Memory Stick Pro™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™ from the machine while it is reading it (when the Graphic (PhotoCapture) key is flashing). You could lose your data or damage the data.
If you take out the memory card while the PhotoCapture key is flashing, you must restart your Macintosh® before putting the same media back into the machine. If you do not restart your Macintosh®, the data on your media may be destroyed.
Page Top
Home PrintPrevious Next