Search

Site Map

Home > Routine Maintenance > Clean Your Brother Machine > Clean the Outside of the Machine

Clean the Outside of the Machine

IMPORTANT
  • Cleaning with volatile liquids such as thinner or benzine will damage the outside surface of the machine.
  • DO NOT use cleaning materials that contain ammonia.
  • DO NOT use isopropyl alcohol to remove dirt from the control panel. It may crack the panel.
  1. If the paper support flap is open, close it, and then close the paper support.
  2. Pull the paper tray (1) completely out of the machine.
    image
  3. (DCP-T536DW/DCP-T730DW/DCP-T735DW) Lift the paper support (1), and then pull it at an angle completely out of the machine as shown by the arrow.
    image
  4. Wipe the outside of the machine with a dry, lint-free cloth to remove dust.
    image
  5. (DCP-T830DW/DCP-T835DW/MFC-T930DW) Lift the output paper tray cover and remove anything that is stuck inside the paper tray.
    image
  6. Wipe the inside and the outside of the paper tray with a dry, lint-free cloth to remove dust.
    image
  7. (DCP-T536DW/DCP-T730DW/DCP-T735DW) Wipe the outside of the paper support with a dry, lint-free cloth to remove dust.
    image
  8. (DCP-T536DW/DCP-T730DW/DCP-T735DW) Put the paper support firmly back in the machine. Make sure you fit the paper support into the channels.
    image
  9. (DCP-T830DW/DCP-T835DW/MFC-T930DW) Close the output paper tray cover and slowly push the paper tray completely into the machine.
  10. (DCP-T536DW/DCP-T730DW/DCP-T735DW) Slowly push the paper tray completely into the machine.
Related Information
Did you find the information you needed?

find moreaccept