Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your machine's control panel to configure your wireless network settings.
- Press
(Wi-Fi) three times. The Wi-Fi LED starts flashing. - Press the WPS button on your wireless access point/router.
If your wireless device is connected successfully, the Power LED and Wi-Fi LED are lit.
You have completed the wireless network setup. To install the drivers and software necessary to use your machine, go to your model's Downloads page at support.brother.com/downloads.
Did you find the information you needed?