Search

Site Map

Home > Machine Settings > Change Machine Settings from the Control Panel > Set the Machine to Power Off Automatically Using the Machine's Control Panel

Set the Machine to Power Off Automatically Using the Machine's Control Panel

The Auto Power Off feature can reduce power consumption. If the machine does not receive any jobs for a certain length of time, based on your model and settings, the machine will automatically enter Power Off mode. The machine will not go into Power Off mode if it is connected to a network, a USB cable, or Wiress Direct. The available features and interfaces vary depending on the model.
To turn on the machine after the Auto Power Off feature has turned it Off, press image(Stop).
  1. Press image (Stop) and the Colour Copy button simultaneously.
    The Power LED, Paper Warning LED, and Ink LED light up for one second, and then the Power LED turns off and the Paper Warning LED and Ink LED start flashing.
  2. Press the Mono Copy button.
    The Power LED and Paper Warning LED light up and the Ink LED turns off for one second, and then the Power LED and Ink LED start flashing.
  3. Press the Colour Copy button as shown in the table to set the Power Off time.
    Number of button presses
    Setting
    One time
    Off
    Two times
    20 minutes
    Three times
    1 hour
    Four times
    2 hours
    Five times
    4 hours
    Six times
    8 hours
    image
    • The setting will stay as 8 hours, even if you press the button more than six times. To change the setting again, press image (Stop), and then repeat the above steps.
    • You can confirm if the correct time has been set by checking the Auto Power Off setting in Web Based Management.
  4. Press image (Copy Shortcut) to complete the setup.
    The Power LED flashes three times, and then it stays lit.
Related Information
Did you find the information you needed?

find moreaccept