Home > Machine Settings > Change Machine Settings from the Control Panel > General Settings > Set the Continue Mode
Set the Continue Mode
The Continue Mode forces the machine to continue printing after the control panel indicates ""Replace Toner" status" and the printing will continue until the control panel indicates ""Toner Ended" status".
This mode is disabled by default. To enable it, change the setting to “Continue”.
- When the control panel indicates an error, you cannot change the mode.
- If you continue printing in the Continue Mode, we cannot guarantee the print quality. To exit Continue Mode, change the setting to “Stop”.
- While using Continue Mode the print may appear faint.
- After you have replaced the toner cartridge with a new one, Continue Mode will be automatically disabled.
- Some machines may not print even if they are in Continue Mode and the “Replace Toner” status is indicated on the control panel. In this case you must replace the toner.
- Press 设置.
- Press
or 
to display the [General Setup] option, and then press OK. - Press or to display the [Replace Toner] option, and then press OK.
- Press or to display the [Continue] or [Stop] option, and then press OK.
- Press 停止/退出.
Did you find the information you needed?