Ethernet (for wired network only)

Ethernet link mode. Auto allows the print server to operate in 100BaseTX full or half duplex, or in 10BaseT full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been reset (default is Auto).
Note Note
 
If you incorrectly set this value, you may not be able to communicate with your print server.
1
Press Menu.
2
Press Bsymbol.utri or Bsymbol.dtri to select LAN.
Press OK.
3
Press Bsymbol.utri or Bsymbol.dtri to select Wired LAN.
Press OK.
4
Press Bsymbol.utri or Bsymbol.dtri to select Ethernet.
Press OK.
5
Press Bsymbol.ltri or Bsymbol.rtri to select Auto/100B-FD/100B-HD/10B-FD/10B-HD.
Press OK.
6
Press Stop/Exit.