5 Wireless Configuration for Macintosh using the Brother installer application (For DCP-373CW, DCP-375CW, DCP-377CW, DCP-593CW, DCP-595CW, DCP-597CW, MFC-495CW and MFC-795CW)

IMPORTANT

•	The following instructions will install your Brother machine in a network environment using the Brother installer application for Macintosh found on the CD-ROM we have provided with the machine.
•	You can also setup your Brother machine using the machine’s control panel which we recommend. You can find instructions in the supplied Quick Setup Guide or see Configuring your machine for a wireless network (Not available for DCP-365CN, DCP-395CN and MFC-295CN).
•	You must know your wireless network settings before you proceed with this installation. If you are going to connect your Brother machine to your network, we recommend that you contact your system administrator prior to installation.

Configuration in Infrastructure mode

Before configuring the wireless settings

IMPORTANT

•

If you have previously configured the wireless settings of the machine, you must reset the network LAN settings before you can configure the wireless settings again.

(For DCP-373CW, DCP-375CW, DCP-377CW, MFC-253CW, MFC-255CW and MFC-257CW)

Press Menu,

to choose Network, press OK. Press

to choose Network Reset, press OK. Press 1 or

to reset and then press 1 or

to accept the change. The machine will restart automatically.

(For DCP-593CW, DCP-595CW, DCP-597CW and MFC-495CW)

Press Menu,

to choose Network, press OK. Press

to choose Network Reset, press OK. Press 1 or + to reset and then press 1 or + to accept the change. The machine will restart automatically.

(For MFC-795CW)

Press MENU,

to display Network, press Network. Press Network Reset, and choose Yes to reset and then press Yes for 2 seconds to confirm. The machine will restart automatically.

•

Your Brother machine supports the use of the first WEP KEY only. If you are using a router that is using more than one WEP KEY enter the KEY used for the first WEP KEY.

•

You need to temporarily use an Ethernet cable (not included) during configuration.

•

Before configuring your machine we recommend you write down the SSID and Password (if required) for your wireless network. You will need this information before you continue with the configuration.

Item	Record the current wireless network settings
Network name: (SSID/ESSID)
Password

Page Top