Home > Network Security > Use IPsec > Configure IPsec Using Web Based Management
Configure IPsec Using Web Based Management
- Start your web browser.
- Type "https://machine's IP address" in your browser's address bar (where "machine's IP address" is your machine's IP address).
For example:
https://192.168.1.2
Your machine's IP address can be found in the Network Configuration Report.
- If required, type the password in the Login field, and then click Login.The default password to manage this machine’s settings is located on the back or base of the machine and marked "Pwd". Change the default password by following the on-screen instructions when you first log in.
- In the left navigation bar, click .If the left navigation bar is not visible, start navigating from .
- Configure the settings.
Option Description Status Enable or disable IPsec.
Negotiation Mode Select Negotiation Mode for IKE Phase 1. IKE is a protocol that is used to exchange encryption keys in order to carry out encrypted communication using IPsec.
In the Main mode, the processing speed is slow, but the security is high. In the Aggressive mode, the processing speed is faster than in the Main mode, but the security is lower.
All Non-IPsec Traffic Select the action to be taken for non-IPsec packets.
When using Web Services, you must select Allow for All Non-IPsec Traffic. If you select Drop, Web Services cannot be used.
Broadcast/Multicast Bypass Select Enabled or Disabled.
Protocol Bypass Select the checkboxes for the option or options you want.
Rules Select the Enabled checkbox to activate the template. When you select multiple checkboxes, the lower numbered checkboxes have priority if the settings for the selected checkboxes conflict.
Click the corresponding drop-down list to select the Address Template that is used for the IPsec connection conditions. To add an Address Template, click Add Template.
Click the corresponding drop-down list to select the IPsec Template that is used for the IPsec connection conditions. To add an IPsec Template, click Add Template.
- Click Submit.
If the machine must be restarted to activate the new settings, the restart confirmation screen will appear.
If there is a blank item in the template you enabled in the Rules table, an error message appears. Confirm your choices and click Submit again.