Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless Network > Configure Your Machine for a Wireless Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
Configure Your Machine for a Wireless Network Using the One-Push Method of Wi-Fi Protected Setup™ (WPS)
If your wireless access point/router supports Wi-Fi Protected Setup™ (WPS), you can use WPS from your machine's control panel to configure your wireless network settings.
- Slide the Mode Select Switch to
. The Wi-Fi LED blinks. - Press and hold the WPS button on your machine for two seconds.The Wi-Fi LED starts to blink more rapidly.
- Press the WPS button on your wireless access point/router.
If your machine is connected successfully, the Wi-Fi LED stop blinking and becomes lit.
You have completed the wireless network setup. To install drivers and software necessary for operating your machine, go to your model's Downloads page at support.brother.com/downloads.
Did you find the information you needed?



