LED indications |

Lighting condition	Machine status	Reference
Lights steadily	The machine is now connected to the mobile device.	Pairing the machine and app
Blinking pattern 1 (3 sec. interval)	The machine is not connected.	Pairing the machine and app
Blinking pattern 2 (1.5 sec. interval)	Preparing for pairing: The app to be paired has not yet been selected, such as while specifying initial settings or reconnecting.	Pairing the machine and app
Blinking pattern 3 (0.5 sec. interval)	Preparing for pairing: The app to be paired has been selected, but a connection is not yet established. (When the machine is turned on for subsequent times, when the connection with the app is lost, etc.)	Pairing the machine and app, If a communication error occurs
Blinking pattern 4 (0.25 sec. interval)	Data is being received.	—

Lighting condition	Machine status	Reference
Blinking	The machine status differs depending on the color of the “Start/Stop” button LED. If the “Start/Stop” button LED lights steadily in orange, the machine is in Needle/thread exchange mode. Hold down the Accept button to exit Needle/thread exchange mode. If the “Start/Stop” button LED is off, the machine is ready to set the embroidery carriage to the initial position, or for a “Trial run”. Follow the instructions in the app. If the “Start/Stop” button LED lights steadily in red, a machine error, such as a broken thread, has occurred and needs to be resolved. Follow the instructions in the app to resolve the corresponding error, and then press the Accept button.	Needle/thread exchange mode

Lighting condition

Machine status

Reference

Blinking

The machine status differs depending on the color of the “Start/Stop” button LED.

If the “Start/Stop” button LED lights steadily in orange, the machine is in Needle/thread exchange mode. Hold down the Accept button to exit Needle/thread exchange mode.
If the “Start/Stop” button LED is off, the machine is ready to set the embroidery carriage to the initial position, or for a “Trial run”. Follow the instructions in the app.
If the “Start/Stop” button LED lights steadily in red, a machine error, such as a broken thread, has occurred and needs to be resolved. Follow the instructions in the app to resolve the corresponding error, and then press the Accept button.

Lighting condition	Machine status	Reference
Lights steadily in green	The machine is embroidering. Press this button to stop embroidering.	Embroidering a Pattern
Blinks in green	Ready to embroider. Press this button to start embroidering. (Blinks after data reception is finished or when a different thread color should be installed.)	Embroidering a Pattern
Lights steadily in orange	In Needle/thread exchange mode or the bobbin is being wound. In Needle/thread exchange mode, the Accept button LED blinks. In this mode, nothing happens when this button is pressed. If this button is pressed while the bobbin is being wound, bobbin winding stops.	Winding the bobbin, Needle/thread exchange mode
Blinks in orange	Ready to wind the bobbin. Press this button to start winding the bobbin. To cancel this ready state without winding the bobbin, move the bobbin winder shaft toward the front of the machine.	Winding the bobbin
Lights steadily in red	An error has occurred. Follow the instructions in the app to resolve the issue. You can check the details from the icon on the top left of the home screen.	—
Blinks green, red, and orange repeatedly	The machine software is being updated.	Updating Your Machine’s Software
Off	Since pattern data has not yet been received, nothing happens when this button is pressed.	—