Embroidering a Pattern

Prepare embroidery thread colors as shown on the app.

Embroidery patterns are embroidered with a change of thread after each color.

1. Pass the thread through the presser foot hole, and hold it lightly in your left hand.

   Give the thread a little slack.

   
   CAUTION

   When embroidering on large garments, place the fabric on a table so that it does not hang down or extend out. Otherwise, the embroidery unit cannot move freely and the embroidery frame may strike the needle, causing the needle to break and possibly causing injury.

2. Press the “Start/Stop” button to start embroidering. After 5-6 stitches, press the “Start/Stop” button again to stop the machine.

   

   Make sure to prevent any objects or fabric outside of the embroidery frame from overlapping the moving area of the embroidery frame. If the embroidery frame hits another object, the pattern may become misaligned.

3. Trim the excess thread at the end of the seam.

   

   If the thread is left at the beginning of the stitching, it may be embroidered over as you continue embroidering the pattern, making it very difficult to remove the excess thread after the pattern is finished. Trim the thread at the beginning.

4. Press the “Start/Stop” button to start embroidering.

   • Stitching stops automatically with reinforcement and thread cutting after one color has been completed.
     

5. Remove the thread for the first color from the machine.

6. Repeat the same steps for embroidering the remaining colors.

   
   • When the last color is embroidered, the message informing that the embroidering is finished will appear on the app. Follow the instructions in the app to continue embroidering or set another embroidery pattern.

If the thread breaks or the bobbin runs out of thread during embroidering

If the upper thread is broken

1. Tap [Close] to close the error message.

2. Tap [Stitch] in the app.

3. Tap , or to move the needle back the correct number of stitches before the area where the thread broke, and then tap [Done].

   	: Machine

4. Press (Accept button).

   • The Accept button LED goes off.

5. Press (Thread cutter button) to cut the upper and bobbin threads.

6. Thread the upper thread again. (Upper Threading)

7. Press the “Start/Stop” button to continue embroidering.

If the bobbin runs out of thread

1. Tap [Move the frame to the Attach/Detach position] to cut the threads and move the frame to a position where it is easier to remove.

2. Follow steps 1 to 3 of If the upper thread is broken, above.

   	: Machine

3. Press (Accept button).

   • The Accept button LED goes off.

4. Remove the embroidery frame. (Removing the embroidery frame)

5. Install the bobbin thread again. (Installing the bobbin)

6. Attach the embroidery frame again. (Attaching the Embroidery Frame)

7. Press the “Start/Stop” button to continue embroidering.

If the error still appears after replacing the thread, check the following.

• Check if the machine is exposed to strong light. If the machine is exposed to strong light such as direct sunlight or a spotlight, the thread sensor may malfunction.
• In the case of upper thread error, make sure that the thread is passed into the thread take-up lever.
  
  1. Thread take-up lever

Resuming embroidery after turning off the power

The current color and stitch number are saved when embroidery is stopped. The next time the machine is turned on, you have the option to continue or delete the pattern at the app.