Names of Machine Parts |

Names of Machine Parts

Thread guide
Spool pin
Bobbin winder
Grips (2 locations)
Use the grips to transport the machine. (When transporting the machine)
Embroidery carriage
Thread tension dial
Operation buttons and LED (Operation buttons and LED, LED indications)
Handwheel
Turn the handwheel toward the thread tension dial to raise and lower the needle.
Needle threader lever
Thread cutter
Power inlet
Main power switch
Press the right side of the switch (“I”) to turn it on, and the left side (“O”) to turn it off.
Air vents (2 locations)
The air vents allow the air surrounding the motor to circulate. Do not cover the air vents while the machine is being used.

Needle bar thread guide
Needle clamp screw
Presser foot
The presser foot helps control fabric flexibility for better stitch consistency.
Needle plate
Needle plate cover
Bobbin cover

Bluetooth button
Hold down to pair the machine and the app via Bluetooth. (Pairing the machine and app)
The LED beside the button changes its lighting depending on the connection status between the machine and the app.
Accept button
Press this button according to the instructions of the app when LED blinking.
Hold down this button to enter Needle/thread exchange mode. (Needle/thread exchange mode).
Thread cutter button
Press to cut the upper thread and the bobbin thread when embroidering is finished.
Threading position button
Press to move the needle position (the height) appropriate for threading.
“Start/Stop” button
Press to start or stop embroidering. The color and lighting condition of the LED change depending on the status of the machine.
For details on the LED lighting conditions, refer to LED indications.