Home > Troubleshooting > Error and Maintenance Messages
Error and Maintenance Messages
| Message | Cause/Remedy |
|---|
| Barcode error / 錯誤的條碼數据 Record: XXXXX Field: XXXXX | There was an attempt to print barcode labels from a database. The Label Printer displays this message when the selected range of the database includes invalid characters or numbers not supported by the barcode protocol. |
| Check no. of digits entered / 請檢查已輸入＃數位 | The number of digits entered in the barcode data does not match the number of digits set in the barcode parameters. Enter the correct number of digits. |
| Cutter malfunction / 裁刀出錯 | If the tape is jammed in the Cutter unit, remove the tape. Turn the Label Printer off and then on again before continuing. |
| Label too long / 標籤超過最大長度 | The printed label length using the text entered is longer than 999 mm. Edit the text so that the label length is less than 999 mm. |
| System error XX / 系統錯誤XX | Contact Brother customer service. |
| Text too long / 內容已超過標籤長度 | The printed label length using the text entered is longer than the length setting. Edit the text to fit within the set length or change the length setting. |