Tape Cutting Options

Home > Print Labels > Select a Cut Option > Tape Cutting Options

In the Options table, these visual patterns represent parts of your label, as illustrated in the Example column.

	Print area
	Margin
	Laminate margin

Setting	Description	Example
Small Margin	A margin of 0.9" (23 mm) is printed first, and then each label is printed, leaving a margin of 0.08" (2 mm) before and after the text.	When the label length is approximately 0.9" (23 mm) or more Approximately 0.9" (23 mm) 0.08" (2 mm) When the label length is approximately 0.9" (23 mm) or less Approximately 0.9" (23 mm) 0.08" (2 mm)
Small Margin
Large Margin	The total margin (laminate margin + label margin) is 0.98" (25 mm) either side of the label.	Approximately 0.9" (23 mm) 0.08" (2 mm)
Large Margin		Approximately 0.9" (23 mm) 0.08" (2 mm)
Chain	Select this setting when printing several labels with minimum margins. Feed the tape before using the Tape Cutter, otherwise part of the text may get cut off. Do not try to pull the tape as this may damage the Tape Cassette. A margin of 0.9" (23 mm) is printed first, and then each label is printed, leaving a margin of 0.08" (2 mm) before and after the text.	Approximately 0.9" (23 mm) 0.08" (2 mm) Cut Position
No Cut	Select this setting when printing multiple copies of a label or when using Fabric Iron-On Tapes or other special tapes that cannot be cut by the Tape Cutter of the Label Maker. Feed the tape before using the Tape Cutter, otherwise part of the text may get cut off. Do not try to pull the tape as this may damage the Tape Cassette. When using the special tapes that cannot be cut by the Tape Cutter of the Label Maker, remove the Tape Cassette from the Label Maker and use scissors to cut the tape.	Approximately 0.9" (23 mm) 0.08" (2 mm)
Special Tape	Select this setting when using special tape.	Approximately 0.9" (23 mm) 0.08" (2 mm)
Special Tape	Select this setting when using special tape.	Approximately 0.9" (23 mm) 0.08" (2 mm)

When the cut option is set to [No Cut] or [Chain], the cut position is set in the middle of printing area after the last label is printed. When [Start feeding?] appears on the LCD, press OK to feed the tape. Press to return to the text entry screen.
When the cut option is set to [Small Margin], [Large Margin], or [Chain], the message [Cut tape or press Enter to continue.] appears after printing, and the Label Maker enters Cut Pause Mode. By pressing the Tape Cutter Lever, you can cut the tape at the position you set in [Cut Option].

Related Information

Select a Cut Option

Did you find the information you needed?