Search

Home > Troubleshooting > Error and Maintenance Messages

Error and Maintenance Messages

Error Message Cause/Solution
Batt.VeryPoor Replace battery The battery may be depleted. Replace the battery with a new one.

Visit the Brother support website at support.brother.com.

Cannot Update Data Try updating the data again.
  • Check the FTP server setting of the Remote Update function.
  • Make sure the setting file is stored in the specified location.
  • Make sure the file specified by the administrator exists in the folder on the FTP server.
ChargingError Cannot Charge Is battery charging incomplete despite continuous charging?

Confirm that the battery is correctly installed. If charging is still unsuccessful, the battery may be deteriorated. Replace the battery with a new one.

Clock Not Set Set the date and time.
Communication Error
  • Data transfer has been unsuccessful. When sending a template as a BLF file, make sure the model name listed in the file matches your printer's model name.
  • Has the Wi-Fi or Bluetooth connection been interrupted?

    Turn the printer off, and then turn it on again.

Cover Open Close Cover Is the Roll Compartment Cover open?

Check that the Roll Compartment Cover is closed.

High Temp! Is the printer temperature too high?

When the Linerless rolls setting is active and the printer overheats, the error message appears. Wait until the printer cools down.

Invalid Database Record An error will occur when printing a template which specifies an incorrect key code, or a non-existent key code in a linked database.
Low Battery! The error message appears just before printing and when the printer cannot print because of the weak battery although the printer is connected and charged using an adapter, USB cable, or Charging Cradle.
Mass Storage Operation error! Is the printer in mass storage mode?
  • The printer's file system may be corrupted, or a file's name or contents were changed while the file was being transferred or processed. Turn the printer off, and then turn it on again.
  • Do not access the files on the printer during mass storage processing to avoid further problems.
Media Error! Check Loading
  • Is the correct roll installed?

    Check that the correct media type (die-cut label or continuous length tape) and size is installed.

  • Is the roll installed correctly?

    If not, remove the roll, and then reinstall it. For more information, see Related Topics.

  • Is there enough roll remaining?

    If not, install a new roll.

Memory Full! Make sure the data you transfer does not exceed the capacity of the user storage area.
No Template Selected
  • There is no template with the specified number.

    Specify the correct number.

  • When printing a template, an error is indicated if the specified template does not exist.
  • The template was not transferred. Register the template with the specified number to the printer.
Print Data Too Large
  • The printer receives a print job exceeding the maximum print length.
  • Print jobs exceeding 3 m and incompatible files cannot be printed.
Recharge Battery! Does the rechargeable battery have a low charge?

Use the AC Adapter and AC power cord to connect the printer to an electrical socket, or use the car adapter to connect the printer to a DC power socket to charge the battery.

You can also charge the battery using a USB cable (not included).

System Error! XX If the error message is displayed, contact Brother customer service.

WPS did not connect 1 Try to connect again

WPS did not connect 2 Try to connect again

The Wi-Fi router/access point could not be found or multiple Wi-Fi routers/access points were found.
  • Confirm that only one Wi-Fi router/access point within range has the WPS method active and try again.
  • Try again after a few minutes to avoid interference from other routers/access points.
Did you find the information you needed?