Search

Site Map

Home > Set Up Your Printer > Load the RD Roll

Load the RD Roll

  1. Press and hold image to turn the printer off.
  2. Pull up the release levers on both sides of the printer to unlock the Roll Compartment Cover.
    image
  3. Hold the printer by the front, and firmly lift the Roll Compartment Cover to open it.
    image
    CAUTION
    Do not directly touch the Tear Bar with your hands. Doing so may result in injury.
  4. Slide both Roll Guides outwards.
    image
    image
    Rotate the adjuster dial towards you to lock the Roll Guides into place.
    image
    image
  5. Insert the roll so that the label print side is facing up, as shown in the illustration.
    image
    image
    • For fanfold paper

      Insert the fanfold paper as shown in the illustration.

      image
      1. Print side

      Adjust the Roll Guides when using fanfold paper.

  6. Feed the end of the roll under the Media Guide Tips (1).
    Position the end of the paper slightly out of the Label Output Slot.
    image
  7. Close the Roll Compartment Cover until it locks into place.
    image
    CAUTION
    Be careful when closing the Roll Compartment Cover. There is a risk of injury if your finger gets pinched between the upper and lower parts of the cover.
IMPORTANT
  • Do not leave any printed labels in the printer. Doing so will cause label jams.
  • When not in use, remove any rolls from inside the printer and close the Roll Compartment Cover to prevent dust and debris from accumulating in the printer.
Related Information
Did you find the information you needed?

find moreaccept