Home > Set Up Your Printer > Load Media Roll > Load a Linerless Roll
Load a Linerless Roll
To view all supported media rolls, import the Supported Lierless Roll list from Paper Size Setup. For more information, see Related Topics: The Paper Size Setup (For Windows).
For available media information, visit support.brother.com/g/d/f4fi/.
- Press and hold
to turn the printer off. - Pull up the release levers on both sides of the printer to unlock the Roll Compartment Cover.
- Hold the front of the printer, and firmly lift the Roll Compartment Cover to open it.
- CAUTION
- Do not touch the Tear Bar with your hands. Doing so may result in injury.
- Rotate the Adjuster Dial to lock the Roll Guides in the appropriate position.
- Insert the roll so that the label's printing surface is facing up, as shown in the illustration.
- Feed the end of the backing paper under the Media Guide Tips (1).
- Feed the end of the roll through the Cutter Slot.
- Close the Roll Compartment Cover until it locks into place.
- CAUTION
- Be careful when closing the Roll Compartment Cover. There is a risk of injury if your finger gets pinched between the upper and lower parts of the cover.
- IMPORTANT
-
- Do not leave any printed labels in the printer. Doing so will cause label jams.
- When the printer is not in use, remove any rolls from it and close the Roll Compartment Cover.
- NOTE
-
- To prevent printed labels from sticking to the desk, use the Label Support.
- When printing multiple labels, always remove the most recently-printed label to allow the next label to print.
- If roll paper is jammed inside the Printer, open the Roll Compartment Cover and gently remove the paper. Do not use force to pull the paper out of the machine.
Did you find the information you needed?