FAQs & Troubleshooting

Close

MFC-J4410DW

FAQs & Troubleshooting

FAQs & Troubleshooting

MFC-J4410DW

Not your product?

Date: 06/03/2013 ID: faq00002192_009

I configured the "IP Config" method of the machine to "Auto" to assign an IP address automatically, however it was changed to "Static" unexpectedly. I get an error message that indicates IP address is not unique, or a document is printed out by the machine I didn't expected.

When wireless network connection is unstable and the APIPA protocol is enabled, you might experience this difficulty.

Follow these steps below to set the BOOT method back to AUTO and disable the APIPA protocol.


  1. Press Settings(Settings).

  2. Press the Up or Down arrow to display Network. (This step might be skipped in some models.)

  3. Press Network.

  4. Press the Up or Down arrow to display WLAN. (This step might be skipped in some models.)

  5. Press WLAN.

  6. Press the Up or Down arrow to display TCP/IP. (This step might be skipped in some models.)

  7. Press TCP/IP.

  8. Press the Up or Down arrow to display BOOT Method. (This step might be skipped in some models.)

  9. Press BOOT Method.

  10. Press the Up or Down arrow to display Auto. (This step might be skipped in some models.)

  11. Press Auto.

  12. Press the Up or Down arrow to display APIPA. Press APIPA.

  13. Press Off.

  14. Press Home(Home).

Related Models

MFC-J285DW, MFC-J4310DW, MFC-J4410DW, MFC-J4610DW

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit