HL-L2400D
FAQs & Troubleshooting |
HL-L2400D
Date: 09/07/2023 ID: faq00002674_005
Self-Diagnostic
When the Self-Diagnostic message appears on the status monitor, the following LED indications is shown on the control panel.
The Toner, Drum, Paper and Ready LED blinks.
Cause
- The fuser unit does not work correctly.
- The fuser unit is too hot.
Action
Press and hold (Power) to turn the machine off, wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the power on.
HL-L2400D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.