FAQs & Troubleshooting

Close

SDX330D

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 10/03/2018 ID: faqh00000691_002

The mat is fed in at an angle.

Possible Causes (or Results)

Case1 : The mat was inserted into the feed slot at an angle.
Case2 : The corners of the mat are deformed (bent).
Case3 : The rear tray is not pulled out.
Case4 : The feed roller is not positioned correctly.
Case5 : The shaft is released.



 

Solutions

 

----- Case1 -----

Press the image(Feed) button to feed out the mat.
image
 

Re-insert the mat straight in.

image image image

 


 

----- Case2 -----
 

Replace the mat with a new one.


 

----- Case3 -----

Pull out the rear tray.

image

 


 

----- Case4 -----

Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller

image


 

----- Case5 -----

Lock the shaft.
image

 

Related Models

SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.