FAQs & Troubleshooting

Close

HL-4150CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

HL-4150CDN

Not your product?

Date: 20/03/2012 ID: faq00000154_047

Replace Drum

The Brother machine has separate consumables the toner cartridge and the drum unit. Verify you replace only the drum unit and not the toner cartridge. If you want to know their difference, refer to "What is the difference between the toner cartridge and the drum unit?"


DO NOT use cleaning materials that contain ammonia, alcohol, any type of spray, or any type of flammable substance to clean the outside or inside of the machine. Doing this may cause a fire or electrical shock.



image


  • We recommend that you place the drum cartridge on a clean, flat surface with a piece of disposable paper underneath it in case you accidentally spill or scatter toner.

  • To prevent damage to the machine from static electricity, DO NOT touch the electrodes shown in the illustration.

image



 

To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations.

image

Replace the drum following the steps below:

  1. Make sure that the machine is turned on. Press the front cover release button and then open the front cover.


    image



    image



  2. Hold the green handle of the drum unit. Pull the drum unit out until it stops.


    image



    image



  3. Turn the green lock lever (1) at the left of the machine counterclockwise to the release position. Holding the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.


    image



    image



  4. Hold the handle of the toner cartridge and slightly push it to unlock. Then pull it out of the drum unit. Repeat this for all the toner cartridges.


    image



  5. Unpack the new drum unit and remove the protective cover.


    image



  6. Hold the handle of the toner cartridge and slide it into the appropriate colored section of the drum unit until it clicks into place.


    image



    image



    C-Cyan M-Magenta Y-Yellow K-Black

  7. Make sure the green lock lever (1) is in the release position as shown in the illustration.



    image


  8. Match the guide ends (2) of the drum unit to the right arrow marks (1) on both sides of the machine, then gently slide the drum unit into the machine until it stops at the green lock lever.


    image



  9. Turn the green lock lever (1) clockwise to the lock position.


    image



  10. Push the drum unit in until it stops.


    image


    image



  11. Close the front cover of the machine.


    When you replace the drum unit with a new one, you need to reset the drum counter by completing the following steps:


    1. Press + or - to choose Machine Info. Press OK.

    2. Press + or - to choose Reset Parts Life. Press OK.

    3. Press + to choose Drum Unit. Press OK.

    4. Press + to reset the drum unit counter.

 

Related Models

HL-4150CDN, HL-4570CDW

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.