PR650e/PR650eC
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_650e_eas.jpg)
PR650e/PR650eC
Date: 04/03/2009 ID: faqh00000320_000
Why does my thread keep jamming?
The thread could be jamming due to several reasons.
- The upper thread could be tangled. Remove the thread completely from the machine.
The correct size spool cap should be used for the size of the thread spool.
Re-thread the machine according to the directions in the manual.
One Point Advice Place a spool of thread on a spool pin
One Point Advice Upper threading
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race.
One Point Advice When thread got tangled
One Point Advice Lower(bobbin) threading
- The tension could be too tight or too loose.
Set the tension to the best thread tension setting or adjust the tension manually.
- Needle and thread are incorrect. Be sure to use the correct thread and embroidery needle(s).
PR650e/PR650eC, PR655/PR655C
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.