FAQs & Troubleshooting

Close

DCP-T520W

FAQs & Troubleshooting

FAQs & Troubleshooting

DCP-T520W

Not your product?

Date: 29/06/2015 ID: faq00000569_012

Glossy Paper does not feed correctly.

This issue is common when using paper that exceeds the recommended thickness for the machine.

To correct the feeding issue, add more paper to the paper tray. If the paper feed does not improve, check the following steps.

 

STEP 1: Check your paper

 

STEP 2: Verify the paper is loaded correctly

  • Load glossy paper with the shiny side facing down. The coated side of glossy paper is shiny. Avoid touching the shiny (coated) side.
     
  • When you print on Brother Photo paper, load one extra sheet of the same photo paper in the paper tray. An extra sheet has been included in the paper package for this purpose.
     
  • Gently put the paper into the paper tray print side down and top edge in first. Check that the paper is flat in the tray.
    Be careful that you do not push the paper in too far, it may lift at the back of the tray and cause feed issues.

 

STEP 3: Clean the Paper Pick-up Roller

> Click here to see how to clean the paper pick-up rollers.

 

If the issue did not improve, contact Brother Customer Service from "Contact Us".

 

Related Models

DCP-T220, DCP-T310, DCP-T420W, DCP-T426W, DCP-T510W, DCP-T520W, DCP-T710W, DCP-T720DW, DCP-T820DW, HL-T4000DW, MFC-J2330DW, MFC-J2730DW, MFC-J3530DW, MFC-J3930DW, MFC-T4500DW, MFC-T810W, MFC-T910DW, MFC-T920DW

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.