FAQs & Troubleshooting

Close

NX-600

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 18/01/2008 ID: faqh00000405_000

"Lower the presser foot lever." appears on the LCD.

This message appears when the start/stop button, reverse/reinforcement stitch button, thread cutter button or the foot controller is pressed while the presser foot lever is raised.


 

 

  • Proper operation will sound
    One beep
  • Improper(wrong) operation will sound
    Two or four beeps

Related Models

CS-8120, Innov-is 100, Innov-is 1200, Innov-is 1250, Innov-is 1500D/1500, Innov-is 2200, Innov-is 350SE, Innov-is 400, Innov-is 500D, Innov-is 550SE/ 550, Innov-is 600, Innov-is 900, Innov-is 950, Innov-is 955, NX-2000, NX-400Q/400, NX-600, QC-1000, SuperGalaxie 3000/3000C/3000D/3100D

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.