Innov-is XP1
FAQs & Troubleshooting |
Innov-is XP1
Date: 06/08/2018 ID: faqh00000095_017
How do I clean the race?
-
Press the Needle Position button to raise the needle.
-
Turn the main power to OFF.
-
Remove the needle and the presser foot holder.
-
Remove the flat bed attachment or the embroidery unit if either is attached.
-
Slide the needle plate lever toward you.
(1) Slide toward you.
-
Slide out the needle plate with your right hand to remove it.
-
Grasp the bobbin case, and then gently lift out.
If threads remain in the bobbin case, remove them.(1) Bobbin case
-
Use the cleaning brush or a vacuum cleaner to remove any dust or loose threads from the race and its surrounding area.
(1) Cleaning brush
(2) Race
-
Insert the bobbin case so that the mark on the bobbin case aligns with the mark on the machine.
(1) mark
(2) mark
(3) Bobbin caseAlign the and marks.
- Never use a bobbin case that is scratched; otherwise, the upper thread may become tangled, the needle may break, or sewing performance may suffer. For a new bobbin case (part code: XE5342-101 (green marking on the screw), XC8167-551 (no color on the screw)), contact your nearest Brother authorized service center.
- Make sure that you fit the bobbin case properly, otherwise the needle may break.
-
Insert the tabs on the needle plate into the notches in the machine.
(1) Tabs
(2) Notches
-
Press down on the right side of the needle plate to secure it.
Innov-is XP1, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.