TD-4650TNWB
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/lptd4650tnwbeuk.jpg)
TD-4650TNWB
Date: 01/12/2021 ID: faqp00100468_001
How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer
Follow the instructions below:
- Turn off the printer.
- Press and hold the Feed/Pause Button and then turn on the printer.
-
For the Black Mark Sensor
Release the button when the LED is lit in green (5 times) after the green/red LED blinks five times alternately.
The LED color will change in the following order:
Amber (lit) > Red/Amber (blinks 5 times alternately) > Amber (5 times) > Green/Red (blinks 5 times alternately) > Green (5 times) (Release the button here) > Red (5 times) > Green (lit)
For the Gap Sensor
Release the button when the LED is lit in red (5 times) after the green LED flashes five times.
The LED color will change in the following order:
Amber (lit) > Red/Amber (blinks 5 times alternately) > Amber (5 times) > Green/Red (blinks 5 times alternately) > Green (5 times) > Red (5 times) (Release the button here) > Green (lit)
You can also calibrate by using the BPM (Brother Printer Management Tool).
TD-4650TNWB, TD-4650TNWBR, TD-4750TNWB, TD-4750TNWBR
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.