FAQs & Troubleshooting
Popular |
CM300
300 Results
1.
About Blade Extension, Cutting Pressure and Mat
2.
Mat and Cutting Blade Combinations
3.
Mat and Material Combinations
4.
Downloading Optional Design Pattern Collection
5.
Adjusting the Blade Extension
6.
The mat is fed in at an angle and is not fed during cutting / drawing.
7.
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
8.
Can I create the cutting data for ScanNCut from the image data?
9.
The mat or the material catches on a feed roller during cutting/drawing.
10.
List of Error Messages for CanvasWorkspace (ErrSxx / NoteSxx)
11.
List of Error Messages for CanvasWorkspace (Exxxxx / Nxxxxx)
12.
List of Error Messages for CanvasWorkspace (Others)
13.
How To Change the Registered Machine Number That Imports The Optional Pattern Collection (Ex. Disney Pattern and Calligraphy Pattern/Font)
14.
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
15.
What type of data can my ScanNCut machine be used?
16.
What should I do if the scanned and cut positions are misaligned?
17.
Can the Cutting mat or Scanning mat for the ScanNCut (CM series) be used in the ScanNCut DX (SDX series)?
18.
Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
19.
Preparation of Craft Paper / Fabric
20.
Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
21.
Can I create the cutting data for ScanNCut from vector graphics data?
22.
There are deep cuts completely through the mat.
23.
Pattern Collection activation on CanvasWorkspace(Web). [Video]
24.
E12003 appears on the computer screen.
25.
Can different types of material be attached to the same mat for cutting?
26.
Replacing the Blade
27.
E12004 appears on the computer screen.
28.
E00003 appears on the computer screen.
29.
E92002 appears on the computer screen.
30.
E10007 appears on the computer screen.