FAQs & Troubleshooting
Popular |
CM650W
328 Results
1.
About Blade Extension, Cutting Pressure and Mat
2.
Mat and Material Combinations
3.
List of Error Messages for CanvasWorkspace (Others)
4.
Mat and Cutting Blade Combinations
5.
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
6.
Adjusting the Blade Extension
7.
How can I transfer the created/edited data between CanvasWorkspace and my machine via a wireless network?
8.
List of Error Messages for CanvasWorkspace (Exxxxx / Nxxxxx)
9.
List of Error Messages for CanvasWorkspace (ErrSxx / NoteSxx)
10.
Downloading Optional Design Pattern Collection
11.
How to register Your Machine with CanvasWorkspace
12.
Can I create the cutting data for ScanNCut from the image data?
13.
The WLAN Automatic Update Function does not work correctly. What should I do?
14.
Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
15.
What type of data can my ScanNCut machine be used?
16.
How do I Scan for Cutting (Direct Cut) ?
17.
Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
18.
How to Use the Rhinestone Function on CanvasWorkspace for PC [Video]
19.
How to Install and Uninstall the Holder
20.
What should I do if the scanned and cut positions are misaligned?
21.
List of Error Messages
22.
"Please register your machine." appears on the computer screen.
23.
When I created a cutting data scanning my illustration, some areas were not converted to the cutting lines.
24.
Replacing the Blade
25.
Instructions for sending patterns created in CanvasWorkspace to the cutting machine for cutting or drawing.
26.
How to create an account for CanvasWorkspace
27.
I cannot transfer the created/edited data to CanvasWorkspace (Web) or the machine wirelessly. What should I do?
28.
How to connect my machine to a wireless network using the Setup Wizard
29.
I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
30.
The machine is turned off (Auto Shut Down).