CM900
FAQs & Troubleshooting |
CM900
Sort by
9 Results
1. 10/07/2017
Not all of the material to be cut is cut. Some areas remain uncut.
2. 10/07/2017
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
3. 10/07/2017
The mat is fed in at an angle and is not fed during cutting / drawing.
4. 10/07/2017
The mat or the material catches on a feed roller during cutting/drawing.
5. 09/06/2017
I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
6. 16/01/2017
What should I do if the entire pattern is not cut?
7. 16/01/2017
What should I do if part of the material is not cut?
8. 08/08/2016
What should I do if the scanned and cut positions are misaligned?
9. 19/08/2015
There are deep cuts completely through the mat.