FAQs & Troubleshooting
![]() |
Popular |
![](/g/b/img/product/hf_sg3000euk.jpg)
SuperGalaxie3000/3100D
75 Results
1.
Combination of fabric, thread and needle
2.
Fabric and Thread
3.
How do I correctly install a bobbin?
4.
"Set the bobbin holder to the left." appears on the LCD.
5.
When thread gets tangled.
6.
Why does the lower thread keep breaking?
7.
"The pattern combination is too large for the extra large embroidery frame. If you plan to add more patterns, rotate the pattern combination." message appears on the LCD. What does it mean and how do I clear it?
8.
"Lower the buttonhole lever." appears on the LCD.
9.
How do I create a space between characters?
10.
How do I remove the presser foot holder?
11.
How do I thread my machine?
12.
How do I wind the bobbin?
13.
Where do I put the oil in my machine?
14.
"Finish editing the pattern before sewing the pattern." message appears on the LCD. What does it mean?
15.
Fabrics and stabilizer material for embroidery
16.
Embroidery
17.
It is difficult to pass the thread through the needle bar thread guide(hook).
18.
"The pattern is too large for the large embroidery frame." appears on the LCD.
19.
"The safety device has been activated. Is the thread tangled? Is the needle bent?" message appears on the LCD. What does it mean?
20.
"Remove the embroidery frame." message appears on the LCD. What does it mean?
21.
"No more patterns can be added to this combination." message appears on the LCD. What does it mean?
22.
How do I sew buttonholes?
23.
Using the Spool Pin.
24.
"This editing function cannot be used when the pattern is out of the red outline. Use this function after moving the pattern." message appears on the LCD. What does it mean?
25.
Sometimes I insert a memory card or floppy disk, I touch the appropriate icon and the SG3000 screen blanks out then turns back on. Sometimes the designs come up, but when I choose a design, the screen blanks out.
26.
"Cannot read this disk. This disk may be defective." appears on the LCD.
27.
"When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD.
28.
"Cannot change the configuration of the characters." appears on the LCD.
29.
"This button does not operate when the embroidery unit is attached." message appears on the LCD. What does it mean?
30.
"Check and rethread the upper thread." appears on the LCD.