FAQs & Troubleshooting
Popular |
CM300
301 Results
1.
The mat or the material catches on a feed roller during cutting/drawing.
2.
Mat and Cutting Blade Combinations
3.
About Blade Extension, Cutting Pressure and Mat
4.
Downloading Optional Design Pattern Collection
5.
Mat and Material Combinations
6.
Can I create the cutting data for ScanNCut from vector graphics data?
7.
List of Error Messages for CanvasWorkspace (Exxxxx / Nxxxxx)
8.
The mat is fed in at an angle and is not fed during cutting / drawing.
9.
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
10.
What type of data can my ScanNCut machine be used?
11.
Preparation of Craft Paper / Fabric
12.
How To Change the Registered Machine Number That Imports The Optional Pattern Collection (Ex. Disney Pattern and Calligraphy Pattern/Font)
13.
List of Error Messages
14.
Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
15.
What should I do if the scanned and cut positions are misaligned?
16.
The 12" × 24" (305 mm × 610 mm) mat cannot be used with scanning function.
17.
Support OS Information about ScanNCut Link Plug-in for Adobe® Illustrator®
18.
Adjusting the Blade Extension
19.
The mat or the material catches on a feed roller when the mat is being inserted.
20.
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
21.
Pattern Collection activation on CanvasWorkspace(Web). [Video]
22.
When the mat is inserted, the attached material peels off.
23.
Using the USB cable, I connected the machine and my computer, but the “Removable Disk” icon does not appear in “Computer (My computer)” on the computer.
24.
How to Use the Enhanced Image Tracing on CanvasWorkspace for PC [Video]
25.
How to Recall from the Computer
26.
Can I create the cutting data for ScanNCut from the image data?
27.
How to Calibrate the LCD Touchscreen Display
28.
How to Use the Rhinestone Function on CanvasWorkspace for PC [Video]
29.
Cutting/Drawing by Tracing an Image
30.
How to use Enhanced Image Tracing function. [Video]