QC-1000
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_qc1000euk.jpg)
QC-1000
Sort by
20 Results
1. 12/07/2024
"The safety device has been activated. Is the thread tangled? Is the needle bent?" message appears on the LCD. What does it mean?
2. 29/07/2016
"A malfunction occurred. Turn the machine off, then on again." message appears on the LCD. What does it mean?
3. 02/04/2008
"Turn off the power and replace the needle plate." appears on the LCD.
4. 02/04/2008
"The needle is down. Press the needle position button to raise the needle." appears on the LCD.
5. 18/01/2008
"Lower the presser foot lever." appears on the LCD.
6. 06/11/2007
"When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD.
7. 06/11/2007
"The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller." appears on the LCD.
8. 30/06/2006
"Saving the upgrade file. Do not turn MAIN power to OFF." appears on the LCD.
9. 30/06/2006
"OK to save the current setting?" appears on the LCD.
10. 30/06/2006
"In twin needle mode, the needle thread lever cannot be used." appears on the LCD.
11. 30/06/2006
"Connected to PC. Do not disconnect the USB cable." appears on the LCD.
12. 30/06/2006
"OK to automatically lower the presser foot?" appears on the LCD.
13. 30/06/2006
"This function can not be used while the machine is in twin needle mode. Cancel twin needle mode and choose the function again." appears on the LCD.
14. 30/06/2006
"Not enough available memory to save the pattern. Delete another pattern?" appears on the LCD.
15. 30/06/2006
"The bobbin thread is almost empty." appears on the LCD.
16. 30/06/2006
"The bobbin winder safety device has activated. Is the thread tangled?" appears on the LCD.
17. 28/06/2006
"Lower the buttonhole lever." appears on the LCD.
18. 28/06/2006
"Raise the buttonhole lever." appears on the LCD.
19. 28/06/2006
"Check and rethread the upper thread." appears on the LCD.
20. 28/06/2006
"Use the presser foot lifter button to lower the presser foot." appears on the LCD.