1. 10/07/2017

Not all of the material to be cut is cut. Some areas remain uncut.

2. 10/07/2017

The material to be cut/drawn or original to be scanned peels off during cutting/scanning.

3. 10/07/2017

The mat is fed in at an angle and is not fed during cutting / drawing.

4. 10/07/2017

The mat or the material catches on a feed roller during cutting/drawing.

5. 09/06/2017

I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.

6. 16/01/2017

What should I do if the entire pattern is not cut?

7. 16/01/2017

What should I do if part of the material is not cut?

8. 08/08/2016

What should I do if the scanned and cut positions are misaligned?

9. 19/08/2015

There are deep cuts completely through the mat.