FAQs & Troubleshooting
Popular |
CM300
300 Results
1.
Mat and Cutting Blade Combinations
2.
Mat and Material Combinations
3.
Downloading Optional Design Pattern Collection
4.
About Blade Extension, Cutting Pressure and Mat
5.
The mat is fed in at an angle and is not fed during cutting / drawing.
6.
List of Error Messages for CanvasWorkspace (ErrSxx / NoteSxx)
7.
List of Error Messages for CanvasWorkspace (E##### / N#####)
8.
Preparation of Craft Paper / Fabric
9.
The mat or the material catches on a feed roller during cutting/drawing.
10.
Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
11.
E10004 appears on the computer screen.
12.
Adjusting the Blade Extension
13.
The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
14.
What is the Difference between "Pen Holder", "Universal Pen Holder" and "Small Barrel Pen Holder"?
15.
If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
16.
List of Error Messages
17.
How to trace the inside edge of the image on Enhanced Image Tracing function. [Video]
18.
What should I do if the scanned and cut positions are misaligned?
19.
Can I create the cutting data for ScanNCut from vector graphics data?
20.
List of Error Messages for CanvasWorkspace (Others)
21.
ErrS24 appears on the computer screen.
22.
Can I create the cutting data for ScanNCut from the image data?
23.
Attaching & Peeling Off the Material
24.
E00007 appears on the computer screen.
25.
E11010 appears on the computer screen.
26.
Support OS Information about ScanNCut Link Plug-in for Adobe® Illustrator®
27.
How To Change the Registered Machine Number That Imports The Optional Pattern Collection (Ex. Disney Pattern and Calligraphy Pattern/Font)
28.
ErrS90 appears on the computer screen.
29.
ErrS51 appears on the computer screen.
30.
ErrS04 appears on the computer screen.