FAQs & Troubleshooting

Close

SC-2000USB

FAQs & Troubleshooting

FAQs & Troubleshooting

SC-2000USB

Not your product?

Date: 18/11/2020 ID: faqp00001517_000

How do I refill the stamp ink?

If the stamp is faint or incomplete, use the ink bottle (sold separately) to refill the ink.

 

  1. Remove the holder from the stamp.
    Image

  2. Use the ink bottle to add five drops of ink to each refill hole in the stamp.
    Image

    Be extremely careful when adding ink.
    Do not use ink other than that specified, otherwise the stamp may be damaged.
    If too much ink is added, it may start leaking from the stamp's surface. In that case, make a test stamp on scrap paper to remove any excess ink.


  3. Put the holder back on the stamp.

    Immediately after refilling the ink, keep the stamp facing down until the ink begins to flow from the stamp. After refilling the ink, be sure to put the cap back on the refill ink bottle.

Related Models

SC-2000USB

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.