VR
 |
FAQs & Troubleshooting |
Date: 14/12/2022 ID: faqh00101653_000
When tansferring an embroidery data from PE-DESIGN 11 to the embroidery machine connected to the computer with a USB cable, the message "Disk full while accessing [filename]." appears.
This is because the file size of the embroidery data you tried to transfer to the machine exceeds the maximum size of data that the machine can receive.
If your embroidery machine can be connected to a USB flash drive, use the USB flash drive to transfer the embroidery data.
- In PE-DESIGN 11, the file size of the PES file tends to be larger than the previous version because the information stored in the embroidery data has increased due to functional enhancements.
- When embroidery data created with an earlier version of PE-DESIGN is loaded into PE-DESIGN 11 and transferred to the embroidery machine via a USB cable connection, the data will be transferred in the data size of PE-DESIGN 11. If the embroidery data exceeds the maximum size of the machine's removable disk, PE-DESIGN 11 will not be able to transfer the data via a USB cable connection, even if the data could be transferred in previous versions of PE-DESIGN.
Innov-is 4000D/4000, Innov-is V3, Innov-is V3 SE, Innov-is V7, PE-DESIGN 11, VR
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.